Type:

Year:

Editor:

Author:

Amlie, Erik; Fylling, Emil; Eikevåg, Sindre Wold; Nesheim, Ole S.; Steinert, Martin; Elverum, Christer W.

Series:

Institution:

Section:

Page(s):

DOI number:

Abstract:

In Additive Manufacturing (AM), new generations of polymer composites presented as engineering- grade materials provide high-end mechanical properties with the design freedom AM provides. Interlayer anisotropy is the main challenge in both in-situ optimization and post-analysis in transitioning from prototypes to high-performance components in fused filament fabrication (FFF). Recent studies show a direct correlation between layer fusion temperature and mechanical properties. In this paper, we present synchronized position and temperature data and study how a component changes based on layer height and geometry. An IR sensor transfers data while printing a G-code generated by FullControllGcode, printing in a single direction and recording temperature in front of the nozzle. Results show that within each layer, a Δt of 20°C at thinner geometries, the heat loss will provide a reduction in mechanical properties and further heat loss occurs when moving away from the heated bed. By using the presented temperature mesh in further studies, post- printed anisotropic components can be analyzed by FEM, and the FFF process can be adaptively optimized based on location, size and geometry.

Keywords:

Additive Manufacturing, Open source design, 3D printing, Thermal analysis, Layer temperature